Seawater pH Explorer
Precipitation sequence
Dissolved major ions
Model details, precipitation sequence and sources
- CaCO₃ · aragonite/calcite: onset shown near pH 8.8; carbonate-limited in the closed model.
- Mg(OH)₂ · brucite: onset near pH 9.5; strong bulk precipitation around 10–11.
- Ca(OH)₂ · portlandite: conceptual high-pH stage after Mg depletion, beginning near pH 12.1.
4 key takeaways
1 · Sulfate largely stays dissolved
2 · NaCl and KCl need concentration, not pH
3 · Carbonate is the first calcium-removal route
4 · Magnesium dominates the high-pH demand
Background information
Raising the pH of Atlantic seawater (about 35 ppt salinity, initially pH 8.1) at approximately 20 °C by adding hydroxide ions (OH⁻) shifts the carbonate equilibrium and can precipitate calcium and magnesium minerals. The sequence below explains the trends illustrated by the calculator. For reference concentrations and regional comparisons, see typical seawater composition and major ions.
| Stage and solid | Approximate onset | Indicative bulk-precipitation range | Main control |
|---|---|---|---|
| 1 · Calcium carbonate CaCO₃ · aragonite/calcite | pH 8.5–9.0 | pH 9.5–10.0 | OH⁻ shifts bicarbonate toward carbonate. The initial dissolved inorganic carbon inventory limits calcium removal in a closed system. |
| 2 · Magnesium hydroxide Mg(OH)₂ · brucite | pH 9.5–10.0 | pH 10.5–11.0 | Abundant Mg²⁺ consumes added OH⁻, producing a strong precipitation/buffering region near pH 10.5. |
| 3 · Calcium hydroxide Ca(OH)₂ · portlandite | pH 12.0–12.4 | Further precipitation may occur above pH 12.8 | A conceptual high-pH stage after substantial magnesium depletion; residual calcium and ion activities govern the amount formed. |
1 · Calcium carbonate forms first
Natural seawater can already be supersaturated with respect to calcium carbonate. Magnesium, phosphate, organic matter and nucleation barriers can nevertheless delay visible precipitation. As hydroxide is added, bicarbonate is converted to carbonate:
HCO₃⁻ + OH⁻ → CO₃²⁻ + H₂O
Ca²⁺ + CO₃²⁻ → CaCO₃(s)
Visible precipitation can become pronounced around pH 8.8–9.2, depending on conditions. Calcium is approximately 10.3 mmol/kg, whereas dissolved inorganic carbon (DIC) is only about 2.0–2.3 mmol/kg. If that carbon were all fixed as CaCO₃, it could remove only roughly one fifth of the initial calcium in a closed system.
This inventory limit is distinct from the rate or actual yield. Studies of selective calcium precipitation from RO brine also show the importance of reagent choice, temperature and magnesium; their conditions differ from this hydroxide-only seawater illustration.
2 · Brucite consumes hydroxide
With magnesium initially around 53 mmol/kg, Mg(OH)₂ precipitation is a major sink for added hydroxide:
Mg²⁺ + 2 OH⁻ → Mg(OH)₂(s)
Saturation may be approached around pH 9.3–9.8, followed by stronger precipitation around pH 10–11. During a hydroxide titration, the pH can rise slowly near 10.5 while much of the added OH⁻ is consumed by magnesium precipitation.
Once magnesium is substantially depleted, further hydroxide addition raises the pH more sharply. A seawater titration study by Shaw and colleagues observed this plateau; its exact position and extent depend on sample composition and conditions.
3 · Portlandite at very high pH
In a closed system, carbonate limitation can leave roughly 80% of the starting calcium in solution after the initial CaCO₃ stage. Following magnesium depletion, very high hydroxide activity can favour calcium hydroxide:
Ca²⁺ + 2 OH⁻ → Ca(OH)₂(s)
An onset near pH 12.0–12.4 is illustrative; it is not a universal threshold. The seawater titration study noted a slowing of the pH rise around 12.1 consistent with Ca(OH)₂ formation. The residual calcium inventory and solution activities determine the extent of precipitation; pH alone does not establish complete calcium removal.
Using the calculator: “Closed” illustrates the limit imposed by the starting carbon inventory. “Open to CO₂” illustrates continued carbonate supply, without calculating gas-transfer kinetics. The rising CO₂ particles at lower pH depict acidification-driven gas release; they are separate from atmospheric CO₂ uptake during alkalinization.
Published by Lenntech ·
Submit your seawater treatment request
Submit your seawater treatment request