Lenntech Water treatment & purification Lenntech Water treatment & purification

Catalytic Wet Air Oxidation

The CWAO process is capable of converting all organic contaminants ultimately to carbon dioxide and water, and can also remove oxidizable inorganic components such as cyanides and ammonia. The process uses air as the oxidant, which is mixed with the effluent and passed over a catalyst at elevated temperatures and pressures. If complete COD removal is not required, the air rate, temperature and pressure can be reduced, therefore reducing the operating cost.

CWAO is particularly cost-effective for effluents that are highly concentrated (chemical oxygen demands of 10,000 to over 100,000 mg/l) or which contain components that are not readily biodegradable or are toxic to biological treatment systems. CWAO process plants also offer the advantage that they can be highly automated for unattended operation, have relatively small plant footprints, and are able to deal with variable effluent flow rates and compositions.

The process is not cost-effective compared with other advanced oxidation processes or biological processes for lightly contaminated effluents (COD less than about 5,000 mg/l).

Cost Comparison! (PowerPoint)

Process Description

The CWAO process is a development of the wet air oxidation (WAO) process.

Organic and some inorganic contaminants are oxidised in the liquid phase by contacting the liquid with high pressure air at temperatures which are typically between 120°C and 310°C. In the CWAO process the liquid phase and high pressure air are passed co-currently over a stationary bed catalyst. The operating pressure is maintained well above the saturation pressure of water at the reaction temperatures (usually about 15-60 bar) so that the reaction takes place in the liquid phase. This enables the oxidation processes to proceed at lower temperatures than those required for incineration. Residence times are from 30 minutes to 90 minutes, and the chemical oxygen demand removal may typically be about 75% to 99%. The effect of the catalyst is to provide a higher degree of COD removal than is obtained by WAO at comparable conditions (over 99% removal can be achieved), or to reduce the residence time.

Organic compounds may be converted to carbon dioxide and water at the higher temperatures; nitrogen and sulphur heteroatoms are converted to to molecular nitrogen and sulphates. The process becomes autogenic at COD levels of about 10,000 mg/l, at which the system will require external energy only at start-up.

Also interesting is hydrogen peroxide, alternative oxidation with ozone or waste water recycling in combination with other waste water treatment systems.


About Lenntech

Lenntech BV
Distributieweg 3
2645 EG Delfgauw

tel: +31 152 610 900
fax: +31 152 616 289
e-mail: info@lenntech.com

Copyright © 1998-2018 Lenntech B.V. All rights reserved