Lenntech Water treatment & purification Lenntech Water treatment & purification

Desalination Pretreatment

Why a pre treatment?

Reverse Osmosis Thin Film Composite membranes are subject to fouling by suspended materials that are present in seawater. Typical seawater RO foulings are:

Fouling Cause Appropriate Pre-treatment
Biological fouling Bacteria, microorganisms, viruses, protozoan Chlorination
Particle fouling sand, clay (turbidity, suspended solids) Filtration
Colloidal fouling Organic and inorganic complexes, colloidal particles, micro-algae Coagulation + Filtration
Optional: Flocculation / sedimentation
Organic fouling Natural Organic Matter (NOM) : humic and fulvic acids, biopolymers Coagulation + Filtration + Activated carbon adsorption
Coagulation+ Ultrafiltration
Mineral fouling Calcium, Magnesium Barium or Strontium sulfates and carbonates Antiscalant dosing
Oxidant fouling Chlorine, Ozone, KMnO4 Oxidant scavenger dosing:
Sodium (meta)bilsulfite
Granulated Activated Carbon

Seawater Desalination typical pretreatment processes:

A very cost-effective way to avoid biological fouling is seawater chlorination . Unfortunately, chlorine oxidizes the membrane material, therefore only 1000 ppmh can be tolerated.

A common dechlorination process is the injection of sodium bisulfite or metabisulfite, classified as a chlorine scavenger. Another solution is the use of a granulated activated carbon.

NOM, particles and colloids can be removed by so-called "conventional treatment" consisting of coagulation followed by deep media filtration for low turbidity water . Additional steps such as flocculation and sedimentation are added in case of very turbid shallow seawater.

The non-conventional pretreatment for NOM , particles and colloids is ultrafiltration.

An antiscalant solution should be dosed before the reverse osmosis membranes to disperse calcium carbonate and sulfates precipitates in order to avoid scaling.

Fine filtration (5-micron) is required as a last step before the RO membranes to prevent any debris, sand particles or piping material to damage the membranes.

About Lenntech

Lenntech BV
Distributieweg 3
2645 EG Delfgauw

tel: +31 152 610 900
fax: +31 152 616 289
e-mail: info@lenntech.com

Copyright © 1998-2018 Lenntech B.V. All rights reserved